Lucent Technologies MDW 9000/9010 - Manual (Page 24)

22
Programming Buttons & Settings
If you use a feature often, you can program it onto a line button for easy access. If you use a feature
occasionally, see Using Features p. 9. Some features, marked with
◆ on the Programming Codes
list on the next page, must be programmed on a line button and can’t be activated by feature codes.
Other features (marked with • on the Programming Codes list) are settings that affect the way your
phone works. Some settings, such as Personalized Ring, affect all the lines on your phone. During
programming, you still have to select a line button, but it can be
any line button the feature affects. Others,
such as Delay Ring for a single line, are settings that affect a specific line and require you to press it during
programming (these features are noted on the Programming Codes list). Settings remain active until you
program them again.
␣Programming Buttons␣
To program a feature on an unused line button:
1. Label a button for the feature.
2. Press the imprinted Feat button, then dial 00.
3. Press the button you labeled.
4. Dial the programming code (see Programming Codes).
5. Repeat Steps 3 and 4 to program other buttons. (Label the buttons first.)
6. Press the imprinted Feat button, then dial 00.
Programming Settings␣
To program a setting:
1. Press the imprinted Feat button, then dial 00.
2. Press any ICOM or SA button, OR
If the setting affects a specific line, press that button.
3. Dial the programming code (see Programming Codes).
4. Repeat Steps 2 and 3 to program other settings.
5. Press the imprinted Feat button, then dial 00.
Special Characters␣
Features that dial numbers automatically may need special characters to allow for correct dialing or
system response.
Press... See... Means...
Drop s Stop. Halts dialing sequence to allow for system response.
Hold p Pause. Inserts 1.5-sec. pause in dial sequence. Multiple consecutive pauses
allowed.
Conf f Flash. Sends switchhook flash. Must be first entry in sequence.
# # End of Dialing. Used to signal end of dialing sequence or to separate grouped
digits.
Copyright © 1998, Lucent Technologies. MERLIN LEGEND is a registered trademark of Lucent Technologies in the U.S. and
other countries.