Legacy Car Audio LCD17A - Manual (Page 4)

Page 3
Page 8
General Controls 1. OPEN BUTT
ON
T
o
remove
the front
panel from
the main
body,
press the
RELEASE key
,
and the
anti-theft LED
indicator will
keep flashing
until the
front panel
is
re-fixed to
the main
body.
2. POWER ON/OFF In power of
f (ACC on)
mode, turn on
the unit by
pressing the POWER
button
on the
front panel.
You
can also
turn on
the unit
by inserting
a disc
into the
CD slot.It will
start playing the
first track on
the disc. Press
the POWER button
to turn of
f the unit.
3 & 4.VOLUME
UP(+)/DOWN(-) BUTTONS
Press the
volume
UP(+)
or
DN(-)
button to
raise or
lower the
volume level
during playback. Both
buttons are also
used to adjust
the settings f
or Bass,
Treble, Balance,
Fader, when
you are in
those audio modes.
5. MUTE ON/OFF
BUTTON
Press the
mute(MU) buttont
to turn
off the
sound temporarily
.
Press it
again to
resume listening.
6. AUDIO
FUNCTION AND
MENU SELECT/ADJUST
1)Audio mode select
and adjustment:
Press the
SEL button
repeatedly to cycle
through four audio
modes:
-> VOLUME
->BASS ->TREBLE ->
BALANCE -> F
ADER
After
selecting a certain
audio mode, you
can adjust the
setting for
Bass, T
reble
Balance, fader
by pressing
the
UP(+)
or
DN(-)
button.
The control
mode of E.
VOL is
operated with following
numeric display
.
- VOL:
(MIN)00, 01,......45,
46(MAX).
- BASS/TREB: -6,
-5,...,00,...5,6
- BAL:
9L, 8L,...,00,...8R,9R
- F
AD: 9F
,8F,...,00,...8R,9R
In each mode,
the waiting time
is about 3
seconds before it
returns to
the last
display mode
of RADIO
or CDP
mode.
7. EQ BUTT
ON
Press the
EQ button
to access
the p
reset equalizer
mode. Press
it
repeatedly
to choose EQ
OFF
, or
4 preset equalizer
curves: FLA
T
, CLAS,
ROCK, POP
. The
audio output
will change
correspondingly.
8. LOUDNESS BUTT
O
N
Pressing and holding
the LOU button
will activate LOUDNESS
function for
enhanced bass
sound at
low levels.
Pressing and
holding it
again will
cancel
loudness effect.
TROUBLE SHOOTING PROBLEM No power Disc cannot be loaded or ejected
CAUSE
The fuse is blown
Another CD is present in the player Disc incorrectly inserted upside-down CD is extremely dirty or defective T
emperature inside the car is
too high Condensation Volume
is too low
No sound
Sound skips
The anten
na cable is not
connected
Insert the antenna cable firmly
The radio
does
not work
Wiring is not properly connected The installation angle is more than 30 degrees CD is extremely dirty or defective
Clean the CD or try a diffe
rent CD
Adjust the installation angle to less than 30 degrees Adjust volume to desired level Check the wiring connection Turn of
f the player for at least an
hour, th
en try again.
Give enough time for the temper- ature in the vehicle to cool down. Clean the CD or try a diffe
rent CD
Insert the CD with label face up
Remove CD in the player
, then insert
a new one with label face up
Replace the fuse
The car ignition is not on.
If the power supply is properly connected to the car,
switch the
ignition key to " ACC
"
SOLUTION
Before using the check list please make all the connections first. If you still have questions after going through the checklist, please
consult
your local customer service representative.