La Crosse Technology WS-9037U-IT - Manual (Page 35)

8
light up briefly. Following time as 12:00 and the indoor temperature will be displayed.
If they are not shown in LCD after 60 seconds, remove the batteries and wait for at
least 60 seconds before reinserting them.
4. The outdoor temperature from the first sensor (channel 1) should then be displayed
on the Temperature Station. Also, the signal reception icon will be displayed. If this
does not happen after 2 minutes, the batteries will need to be removed from both
units and reset from step 1.
5. Insert the battery into the second sensor immediately after (within 10 seconds after)
the reading form the first sensor is shown on LCD.
6. The outdoor temperature from the second sensor and the "channel 2" icon should
then be displayed on the Temperature Station. If this does not happen after 2 minute,
the batteries will need to be removed from all the units and reset from step 1.
7. Insert the batteries into the third sensor immediately after (within 10 seconds after)
ithe reading from the second sensor is shown on LCD.
8. Then within 2 minutes, the channel 3 outdoor data from the third sensor will be
displayed and the channel icon will shift back to "1" once the third sensor is
successfully received. If this is not happen, user shall restart the setting up from step
1.
9. In order to ensure sufficient 915 MHz transmission there should be a distance of no
more than 330 feet (100 meters) between the final position of the Temperature
Station and the sensor (see notes on “Mounting” and “915 MHz Reception”).