Lanier 2001 - Manual (Page 82)

Dial Registration
4 - 22 Facsimile Programming
Entering
1
Press the PROGRAM Key and scroll through the
menus until you reach the DIAL REGISTRATION
Menu. Press YES to begin programming.
2
Press 5 or scroll down to the Batch TX menu and
press YES.
3
Press the One-Touch Key you wish to use.
4
Enter the time at which the batch should be
transmitted and press YES to accept.
•
This screen confirms your entry.
5
Press the START key to enter this information into
memory, or press NO to exit.
Edit/Deleting
1
If you wish to change any entry, a screen allows you to accept or change.
2
If you wish to change a Key that was previously
programmed, this message appears. Press YES to
keep this location as is, or NO if you wish to edit it.
3
If you choose NO, use the arrow keys to select
either EDIT or DELETE and then proceed with the
needed changes.
DIAL REGISTRATION?
YES / or 1-5
5 BATCH TX?
-SELECT REGIST.KEY-
OK=YES
ONE-TOUCH 25
TX TIME=_0:00
OK=YES
*SET ONE-TOUCH 25
23:00
-SELECT REGIST. KEY-
(COMPLETE=NO)
REGISTERED! KEEP?
OK=YES (EDIT/DEL=NO)
EDIT *DELETE
-SELECT&PUSH”YES”-