Lanier 2001 - Manual (Page 114)

Set Printer (2002 Only)
5 - 6 PC Printing & Scanning
PCL4
Allows users to select PCL4 printer emulation which supports 300 dpi. If the LCD
displays, “PCL4/GDI CHANGE, RESTART YOUR FAX” because memory
reallocation (refer to Memory required for printer” ), it is necessary to power OFF the
fax machine and then turn the power back ON (wait approximately 6 seconds before
turning unit back ON).
Note: Please be sure to print (clear) any documents from Fax memory before
selecting PCL4.
1
Press the PROGRAM Key and scroll through the
menus until you reach the Set Printer menu and
press YES.
2
Press 7 or scroll down to the PCL4 Enhance menu
and press YES.
3
Select either ON or OFF depending on your needs.
Press YES to accept this data into memory.
4
If you chose YES, you must restart your unit to
make this change active.
SET PRINTER?
YES / or 1-8
7 PCL4 ENHANCE?
OK=YES
ON *OFF
-SELECT&PUSH”YES”-
PCL4/GDI CHANGE
RESTART YOUR FAX