Lanier 2001 - Manual (Page 84)

TX Operation
4 - 24 Facsimile Programming
Closed Network TX
When closed network TX/RX mode is set ON, transmission is possible only with the
destination stations registered in One-Touch and Speed Dial.
1
Press the PROGRAM Key and scroll through the
menus until you reach the TX Operation Menu.
Press YES to begin programming.
2
Press 1 or scroll down to the Closed Network menu
and press YES.
3
Using the Left and Right arrows, select the option
you wish to have as the default and press YES to
enter this selection into memory.
Fax Forwarding
This allows a user to set 20 different remote telephone numbers for fax forwarding. If
you specify a telephone number, only those messages from that number will be
forwarded. If you don’t specify a remote telephone number, all the incoming message
will be forward to specified location.
1
Press the PROGRAM Key and scroll through the
menus until you reach the TX Operation Menu.
Press YES to begin programming.
2
Press 3 or scroll down to the Fax Forwarding menu
and press YES.
3
Select a location number 01 through 20 to which
you wish forward your messages. Press YES to
enter this selection into memory.
4
Select either ON or OFF and press YES.
5
Select the day you wish the forwarding to begin
and press YES.
TX OPERATION?
YES / or 1-2
2 CLOSED NETWORK?
OK=YES
ON *OFF
-SELECT&PUSH”YES”-
TX OPERATION?
YES / or 1-2
3 FAX FORWARDING?
OK=YES
FORWARD NO.=_1
OK=YES / or 01-20
FORWARD TX =ON
OK=YES
SEL. START DAY=SUN.
OK=YES / or 0-6