Lindy LF1TBELRG - Manual (Page 20)

LINDY CPU Switch Smart Installation and Use Page 13
keyboard cable and so will power itself on when the attached PC is switched on or
when the optional power adapter is connected. Do not release the key until the
LINDY CPU Switch Smart displays ’C’ to show that it has entered configure mode.
To enter configure mode whilst the LINDY CPU Switch Smart is running:
Hold down the front panel key for 5 seconds until the front panel display shows ‘C’.
In configure mode, options are entered by typing a letter followed by a number
followed by (return). Use ESC to abort the entry of an option. The LINDY CPU
Switch Smart will remain in configure mode until you type 'E' (return).
For example: to set hotkey option 2 type the following at the 'C' prompt
(at LINDY CPU Switch Smart 'C' prompt)
+  I
To exit configure mode type:
( I
2.7 Summary of LINDY CPU Switch Smart configuration options
Full details of each of the configuration options and their uses are given in section 4.
B1 - screen saver disabled (default)
B2 - Blank screen after 1 minute of inactivity
B3 - Blank screen after 2 minutes of inactivity
B4 - Blank screen after 4 minutes of inactivity
B5 - Blank screen after 8 minutes of inactivity
B6 - Blank screen after 12 minutes of inactivity
B7 - Blank screen after 16 minutes of inactivity
B8 - Blank screen after 20 minutes of inactivity
L1 - CPU Switch Smart locks on to active ports only during autoscanning (default)
L2 - CPU Switch Smart locks on to every port during autoscanning
L3 - CPU Switch powers on in autoscan mode and locks on to active ports only
L4 - CPU Switch Smart powers on in autoscan mode and locks on to all ports
L5 – Allow the mouse to run at any speed (default)
L6 – Don't allow the mouse to run at very slow speeds