Lexmark 436 - Manual (Page 114)

Custom Scan Sizes menu
Menu item Description
Custom Scan Size <x>
Width
1–8.50 inches (25–216 mm)
Height
1–14 inches (25–356 mm)
Orientation
Portrait
Landscape
2 scans/side
Off
On
Specifies a custom scan size name and options. This name replaces a Custom
Scan Size <x>
name in the printer menus. <x> can be either 1 or 2.
Notes:
• The panel displays “ID Card” in place of “Custom Scan Size 1” unless you
have named it differently.
• 4.65 inches is the US factory default setting for Width for Size 1.
118 millimeters is the international factory default setting for Width for
Size 1.
• 8.5 inches is the US factory default setting for Width for Size 2.
216 millimeters is the international factory default setting for Width for
Size 2.
• 6 inches is the US factory default setting for Height for Size 1.
154 millimeters is the international factory default setting for Height for
Size 1.
• 14 inches is the US factory default setting for Height for Size 2.
356 millimeters is the international factory default setting for Height for
Size 2.
• Landscape is the factory default setting for Orientation.
• Off is the factory default setting for 2 scans/side for Size 2.
• On is the factory default setting for 2 scans/side for Size 1.
Universal Setup menu
These menu items are used to specify the height, width, and feed direction of the Universal Paper Size. The Universal
Paper Size is a user
‑defined paper size. It is listed with the other paper size settings and includes similar options, such
as support for duplex printing and printing multiple pages on one sheet.
Menu item Description
Units of Measure
Inches
Millimeters
Identifies the units of measure
Notes:
• Inches is the US factory default setting.
• Millimeters is the international factory default setting.
Portrait Width
3–14.17 inches
76–360 mm
Sets the portrait width
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• 8.5 inches is the US factory default setting. Inches can be increased
in 0.01
‑inch increments.
• 216 mm is the international factory default setting. Millimeters can
be increased in 1
‑mm increments.
Understanding printer menus 114