Lexmark 436 - Manual (Page 117)

Menu item Description
NPA Mode
Off
Auto
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
• Auto is the factory default setting
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Network Buffer
Disabled
Auto
Sets the size of the network input buffer
Notes:
• Auto is the factory default setting.
• The value can be changed in 1
‑K increments.
• The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
• To increase the maximum size range for the Network Buffer, disable or
reduce the size of the USB buffer.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Mac Binary PS
On
Off
Auto
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
• Auto is the factory default setting.
• The Off setting filters print jobs using the standard protocol.
• The On setting processes raw binary PostScript print jobs.
Network Setup
Reports Menu
Network Card menu
TCIP Menu
IPv6 Menu
Wireless menu
AppleTalk menu
Lists all the network setup menus, regardless of the active network of the printer
Note: Certain options are not available on selected printer models.
Network Reports menu
This menu is available from the Network/Ports menu:
Network/Ports > Standard Network or Network <x> > Std Network Setup or Net <x> Setup > Reports or Network
Reports
Menu item Description
Print Setup Page Prints a report containing information about the current network setup
Note: The Print Setup Page contains information about the network printer settings, such as the
TCP/IP address.
Understanding printer menus 117