Lexmark 436 - Manual (Page 28)

7 Remove the label covering the USB port on the back of the printer.
8 Temporarily connect a USB cable between the computer on the wireless network and the printer.
Notes:
• After the printer is configured, the software will instruct you to disconnect the temporary USB cable so you
can print wirelessly.
• If your printer has faxing capabilities, then connect the telephone cable.
9 Follow the on
‑screen instructions to complete the software installation.
Note: Basic is the recommended path to choose. Choose Advanced only if you want to customize your
installation.
10 To allow other computers on the wireless network to use the wireless printer, follow steps 2 through 6 for each
computer.
Installing the printer on a wireless network (Macintosh)
Before you install the printer on a wireless network, make sure that:
• Your wireless network is set up and working properly.
• The computer you are using is connected to the same wireless network where you want to set up the printer.
Additional printer setup 28