Lionel Trains Baby Toy - Manual (Page 16)

Maintaining and servicing your set
16
Replacing the traction tires
Y our locomotive is equipped with one traction tire (Lionel part no. 620-8613-206). During
the course of normal operations, the traction tire may become worn out. To replace the
traction tire, use a 3/16” nut driver to remove the drive rod nut. Slip off the worn tire and
position the replacement tire around the wheel. Carefully fit the tire into the groove. If you are
uncomfortable with this operation, you may choose to have the traction tire replaced by your
authorized Lionel Service Center.
Replacing your locomotive’s lamp
Y our locomotive is illuminated by one lamp, Lionel part nol 600-0191-300. During the
course of normal operations, the lamp in your locomotive may require replacement.
Replacement lamps are available at your authorized Lionel Service Center or from Lionel
Service in Chesterfield, Michigan.
1. Disengage the clips on the latern housing from the slots in the bracket. Lift away the
lantern housing.
2. Slide the lamp back towards the locomotive’s stack, then lift the lamp straight up from the
bracket.
3. Install the replacement lamp, sliding it towards the front of the locomotive.
4. Press the lantern housing down into position on the bracket.
Lantern
housing
Flat spring
Bracket
Lionel part
no. 600-0191-300
Clip
Figure11. Lamp replacement