Legend Audio ATP 7500 - Manual (Page 5)

System Setup
We urge you, at least the first time you set up your system, to
take the time and thoroughly follow each of the following
steps precisely. Even though this may take some time, it will
guarantee that your system will function properly and offer
the most rewarding results. If you “do it right” the first time,
future changes will be easier to implement.
Press the “MENU” button on the remote and the On Screen
Display (OSD) will appear as in the example below:
Using the Remote’s keypad, press the button corresponding to
what you want to setup. Selected function will be highlighted.
1. Speaker Size
Speaker size refers to your speaker’s actual frequency
response. For each channel, selecting “large” means that the
channel will be set to “full range” by the processor. Selecting
“small” means that the processor will filter out the low bass
from this channel and redirect this part of the signal to the
subwoofer. For some channels you may select “none” if you
don’t use a speaker for that channel.
2. Speaker Distance
You will need to set the distance, in feet, between your
listening position and each speaker. These settings automatically
calculate the accurate delay settings for each channel. Select
the number of the channel you wish to set, then press the
SELECT button to increase the distance. This setting is in
increments of 1 foot up to 30 feet, then start over at 1 foot.
3. Input Assignment
The default input assignment settings will be shown on the
screen. You can leave them as is or you may reassign any of
the 6 digital inputs. Select the number corresponding to the
input you wish to change then press the SELECT button. Each
time you press the SELECT button, the selected input will
scroll through each available digital input and then return to
the analog input. You may associate each analog input to any
digital input. Keep in mind that each analog input is labeled
on the back of the unit by its name, unlike the digital inputs
which are numbered 1 through 6.
Page 5
1. Quick Setup – Speaker size
2. Quick Setup – Speaker distance
3. Input assignment
4. Tuner / PAL / NTSC Settings
5. Bass trim
6. Calibration
7. Compression
8. Status Display
9. DVD Audio Full Range
0. Reset to Defaults
Exit
FIGURE 1: MAIN MENU
1. Front speakers
– Toggle to small or large
2. Center speaker
– Toggle to small, large or none
3. Surround speakers
– Toggle to small or large
4. Rear speakers
– Toggle to small, large or none
5. Subwoofer
– Toggle to yes or no
Exit – Return to main menu
FIGURE 2: SPEAKER SIZE MENU
1. VCR1
2. VCR2
3. TV
4. LD
5. AUX
6. SAT
7. DVD
8. CD
9. TAPE
Exit – Return to main menu
FIGURE 4: INPUT ASSIGNMENT MENU
1. Set left front speaker distance
2. Set center speaker distance
3. Set right front speaker distance
4. Set right surround speaker distance
5. Set right back speaker distance
6. Set left back speaker distance
7. Set left surround speaker distance
Exit – Return to main menu
FIGURE 3: SPEAKER DISTANCE MENU