LG 26LH1DC5 - Manual (Page 54)

54
COMMER
CIAL MODE
COMMERCIAL MODE
CLONING CONNECTIONS/LEARNING SETUP
*Note1: It is assumed that the 26LH1DC3/4/5 is connected to a signal source, the source selected is Antenna (RF) In, the signal is from
an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone Programmer main menu
(THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, the clone programmer LED is blinking the required heart
beat pattern, see above and next page.
*Note2: Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance while the
clone is operating may disrupt the master setup transfer or copying etc.
- Connections for the LT2002 Clone Programmer to Learn the 26LH1DC3/4/5 Master TV Setup
Clone Programmer
Master 26LH1DC3/4/5
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
QuickSet II Programmer
LT2002
¤
Ferrite Core
(TDK, ZCAT
2035-0930)
Antenna
or CATV
Warning: Do not use LT2002
if a Lodge Net PPV card is
installed in TV or clone
programmer device will be
damaged.
Before you begin cloning...
• The Master 26LH1DC3/4/5 should be connected to
a good, stable signal from an over-the-air antenna or
cable service Analog channel and connected to power.
(See above.)
• Teaching and Learning is only possible between
identical model devices. (However, the LT2002 Clone
programmer can store up to 3 different ‘master’
setups.)
WARNING: Copying a blank or incorrect memory into a
TV, STB or other device will cause the TV, STB or
other device to operate erratically or become
inoperable.
• Use an Installer’s remote to operate Learning and
Teaching menus.
• Make sure that the batteries in the Clone programmer
are fresh.
• If batteries are removed, the Clone Clock time will be
lost.
• Decide if you want to set the time from the Clone
programmer TV which has the clock set to the current
time.
• Setting the time and transferring it to the Clone or
other device is a separate procedure.
• Follow the connection diagram above to connect the
Clone to a Master 26LH1DC3/4/5 TV display panel.
After learning is complete, to another identical
26LH1DC3/4/5 TV display panel to “teach” it the
master setup.
• After the 26LH1DC3/4/5s setup has been copied to
another identical 26LH1DC3/4/5, that identical unit
with the copied setup, needs to be disconnected from
power for about 15 seconds to activate the
newly-copied setup.
• See the Clone Troubleshooting section to resolve
problems.
Turn to the next page to continue Cloning Setup.