Lexmark MARKNET N8050 - Manual (Page 13)

Using the Wireless Setup Utility
9
5 Select the appropriate encryption for the network. The type of encryption that can be used is
dependent on the authentication type that was selected in step 4.
For Open:
• No Encryption
• WEP
For Shared:
• WEP
For WPA Personal:
• TKIP
For 802.1x–RADIUS:
• No Encryption
• WEP (dynamic keys)
• WEP (static keys)
• WPA-TKIP
6 If 802.1x–RADIUS using EAP-TLS is the intended authentication type, a certificate request
is needed to obtain a signed certificate for the device. For instructions on requesting a new
signed certificate, see
Creating a certificate request . If a different 802.1x–RADIUS
authentication mechanism is used, skip to step 7.
7 Configure authentication and encryption. If none of the following options are selected,
continue to step 8.
If 802.1x–RADIUS was selected as the authentication type, click Configure
Authentication , and follow the Configuring the authentication mechanism instructions.
If WPA Personal was selected as the encryption type, click Configure Encryption , and
follow the Configuring WPA Personal encryption instructions.
If WEP or WEP (static keys) was selected as the encryption type, click Configure
Encryption , and follow the Configuring WEP encryption instructions.
8 Click Apply .
9 Click OK .
10 Click OK to close the utility.
Configuring the authentication mechanism
• If EAP-MD5 , MSCHAPv2 , or LEAP is selected as the authentication mechanism:
1 Enter an appropriate username and password for the 802.1x–RADIUS authentication
server.
2 Confirm the password.