Lennox Hearth STRIKER SWS160 - Manual (Page 15)

15
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Brick Sizes
A = 4-1/4” x 9”
B = 2-1/4” x 8-7/8”
D = 2-1/4” x 9”
E = 1-1/2” x 8-7/8”
F = Full Brick (4-1/2” x 9”)
G = 1-1/2” x 9”
Figure 14
3. Next, you will install the baffle blanket. It will be installed with the
11” dimension from the front to rear of the firebox. Install by lifting
it into place between the front and rear baffle. Place the blanket over
the rear baffle and rear baffle boards that you have just installed. Next
you will place the baffle blanket that is protruding beyond the front
side rear baffle on the top side of the front baffle.
4. The final step of the baffle board & baffle blanket installation will be
installing the front baffle boards. The front baffle boards will be the
two remaining baffle boards which are the larger two baffle boards
of the four baffle board kit. They will be installed with the 7-3/8”
dimension from the front to rear of the firebox. Start by setting the
back side of the board on the rear baffle making sure that it is placed
far enough back to lift up and onto the front baffle. Next you will place
the front edge of the front baffle boards on the top side of the front
baffle and slide them towards the firebox front until it stops against
the front baffle edge. You will do this with each front baffle board
with one to the right side of the firebox and one to the left side of the
firebox. Confirm that the baffle blanket is directly on top of the baffle
boards and that it does not protrude beyond the front baffle or front
baffle boards as shown in Figure 15 (also see note on Page 14).
17D 18B
5
F
10
F
9
F
8
A
4
F
6
D
1
F
2
F
3
D
7
F
11F 12A 13F 14F
15G 16E
Side Cut-A-Way View of Firebox
Baffle Blanket
Front Baffle
Board
Rear Baffle
Board
Firebox
Brick
Baffle Insulation Parts
Figure 15
Figure 16
11”
18-1/4”
9”
7-3/8”
1” Thickness
Baffle Blanket
1/2” Thickness
Front Baffle Board
(2 included)
1/2” Thickness
Rear Baffle Board
(2 included)
9”
3-9/16”