LifeSource UB-511 - Manual (Page 7)

ABOUT MEMORY
E-8 LifeSource Health Line (Toll-Free): 1-888-726-9966
The UB-511 automatically stores up to 30 blood pressure and
pulse measurements in its memory. Measurements stored in mem-
ory are assigned an index number in the order of the newest to the
oldest. The oldest reading displays as "n01".
To retrieve readings, follow these simple steps:
1. When the display screen is blank, press and hold the START
button. While holding down the START button, you will see
the average reading displayed first. You will then see the
memory index number (e.g. n03) of the most recent reading
followed by the measurement. Release the START button
when you see the memory index number.
2. The display will shut off automatically a few seconds after all
of the readings are displayed. To turn off the monitor at any
time, press the START button.
3. The display will shut off automatically a few seconds after the
readings are displayed.
To clear the measurement history from memory, remove the bat-
teries from the unit and then place the batteries back into the bat-
tery holder.
NOTE: If there are no measurements stored in memory, you will
see two 0s displayed vertically followed by a blinking "A00".
NOTE: Stored measurements will be lost if batteries become low
or are removed.
The Pressure Indicator is located on the left side of the display
screen to tell you when the blood monitor is inflating the cuff.
The indicator consists of a scale with six levels and moves up
during inflation.
E-9
ABOUT PRESSURE INDICATOR
In Canada (Toll-Free): 1-800-461-0991
NOTE: The motor will inflate the cuff at a slow speed starting at
20mmHg to begin the blood pressure measurement process.
Inflation in
Progress
Inflation/Measurement
Complete
Measurement
Displayed
UB511_master 11/2/04 11:38 AM Page 12