Lanner electronic FW-7650 - Manual (Page 47)

3.10 Load Optimized Defaults
When you press “Enter” on this item, you get a confirmation dialog box with a message similar
to:
Load Optimized Defaults (Y/N) ? N
Pessing “Y” loads the default values that are factory settings for optimal performance
system operations
3.11 Supervisor/User Password Setting
Te “SUPERVISOR/USER PASSWORD” utility sets the password. The SBC is shipped with
the password disabled. If you want to change the password, you must first enter the current
password, then at the prompt -- enter your new password. The password is case sensitive, and
can be up to 8 alphanumeric characters. Press <Enter> after you have finished typing in the
password. At the next prompt, confirm the new password by re-typing it and pressing <Enter>
again. When you are done, the screen automatically reverts to the main screen. Remember that
when you use this feature, the “Security Option” line in BIOS FEATURES SETUP will
determine when entering the password will be required.
To disable the password, press the <Enter> key instead of entering a new password when the
“Enter Password” in the dialog box appears. A message will appear confirming that the
password is disabled.
If you have set both supervisor and user password, only the supervisor password allows you to
enter the BIOS SETUP PROGRAM.
Note : If you forget your password, the only way to solve this problem is to discharge the
CMOS memory
3.12 Save and Exit Setup
Pressing <Enter> on this item asks for confirmation:
Save to CMOS and EXIT (Y/N)? Y
Pressing “Y” stores the selections made in the menus in CMOS – a special section of
memory that stays on after you turn your system off. The next time you boot your
computer, the BIOS configures your system according to the Setup selections stored in
CMOS. After saving the values the system is restarted again.