Lenoxx Electronics CD-1492 - Manual (Page 5)

INTRODUCTION
Your new COMPACT DISC PLAYER WITH AM/FM STEREO CASSETTE RECORDER
is a specially designed all solid state set which, with proper care, will give you years of
trouble-free service. Please read these operating instructions carefully as they will
help you obtain maximum performance from this set. Unpack the set carefully and
place it on a level surface, away from sources of excessive heat, such as radiators.
POWER SUPPLY- 2 WAY SYSTEM
This set is designed to be operated from two different power sources as
listed below:
A. DC OPERATION
This set runs on 8 size “D” batteries. For best performance, always use heavy duty
alkaline batteries.
TO INSTALL BATTERIES
1.Remove the BATTERY DOOR by gently pushing tabs downward and outward.
NOTE: To use your set on battery power, you MUST remove the AC power cord
from BOTH the wall outlet AND the back of the set.
NOTE: Do not mix old and new batteries. Do not mix rechargeable (nickel cadmium)
and regular carbon zinc or alkaline batteries. Installation of batteries should
be done by an adult (for safety).
NOTE: The negative polarity
(side) of battery
touches the spring.
B. AC OPERATION
Plug the AC power cord into the back of the set and insert the AC PLUG into 120 Volts
AC 60Hz standard household outlet.
4
POLARIZED AC PLUG
BATTERY INDICATOR
The POWER lamp also shows you if your batteries are fresh. When this lamp
gets dim, it is time to replace the batteries.
NOTE: This cord is polarized. This means either
end of the cord will only fit ONE way into
the socket or wall outlet. If it does not fit, do
not force it, just reverse it and try again.
NOTE: If the AC power cord is plugged into the
back of the set, the set will not work on
batteries. To operate the set on batteries,
remove the AC PLUG from the back of the
set.
IB-CD1492(AD)-WM-E-031402
2.Install 8 size “D” batteries.
NOTE: The battery compartment has 2 levels,
upper and lower. Be sure to install the
batteries as per the sketch shown
and the indication on the back of the set.
3.Replace the BATTERY DOOR.
NOTE: Old batteries may swell and leak. To
avoid damage to your set, remove the
batteries when the set is to be stored for
long periods of time or if the batteries
become exhausted (when the batteries
become weak, the POWER/BATT. lamp will
be dim; when the batteries are completely
dead, the POWER/BATT. lamp will be off).
IB-CD1492(AD)-W-E-031402.p65 3/19/02, 2:16 PM 5