Learning Resources RIGHT TIMER LER 6955 - Manual (Page 6)

10
11
RESUMING THE COUNTDOWN
When you want to start the TIMER again, press the START button to resume counting from
where the unit was paused.
ALARM
An alarm will sound when the time remaining reaches one minute (60 seconds).
STOPPING THE ALARM
The alarm will then sound until you press the STOP button to silence the alarm.
Press the CLEAR button to return the display to the full countdown.
CHRONOGRAPH (Stop Watch) SET
1. Press the MODE button until CHRONO is displayed on the screen.
2. Press the START button to begin counting.
FREEZE THE STOP WATCH!
1. To freeze the display to mark a lap or amount of time, press the FREEZE button once quickly to
pause the display to mark time. The real time count will continue to run even though the screen
is frozen.
2. Press the START button once to un-freeze the display and resume the count at actual elapsed
time.
3. Press the STOP button to receive final readout when you are finished timing.
4. Press the CLEAR button to reset the count to zero after the final count.
ONE HUNDRETHS
OF A SECOND
DISPLAYED
Use and Care Instructions
To protect your Right Timer™ :
• Do not submerge the unit in water.
• Prevent spilling food or beverages on the unit.
• To clean, wipe gently with a barely damp, soft cloth.
• Do not throw the unit and do not push sharp objects through the speaker holes or
LCD display screen.
Replacing Batteries
Change the batteries when the sound becomes garbled or slows down, or when pressing a button
does not trigger a response from the unit. Follow the instructions for inserting the batteries found
on page (?) of this manual.
Important Battery Information
Please read and understand these additional battery usage instructions.
To insure proper function:
Battery installation and replacement should be done by an adult only.
Do not mix old and new batteries.
Do not mix alkaline, standard or rechargeable batteries.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the product before being charged (if removable).
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the product.
Remove batteries if product is to be inactive for long periods of time, to avoid leakage.
The supply terminals are not to be short-circuited.
Replace batteries at the first signs of erratic operations.
WARNING: DO NOT DISPOSE OF BATTERIES IN FIRE.
BATTERIES MAY EXPLODE OR LEAK.
6955 GUD V2 3/19/07 9:47 AM Page 6