Land Pride Accu-Z Razor 357-187M - Manual (Page 26)

24
Section 3: Adjustments
Z44 & Z52 (S/N 526171 & Above) Accu-Z Razor ® Zero Turn Mowers 357-187M 7/22/10
Table of Contents
Refer to Figure 3-9:
5. Set cutting height at 3 1/4” on the height indicator by
placing the height adjusting stop in the 3” hole, and
turning the height adjustment stop so that the flat
side is against the stop handle.
6. Clamp the height adjusting stop against the stop
handle. This will assure that the height will not move
during the setting process. Otherwise, spring
pressure from the deck lift springs will tend to pull the
stop away from the handle.
Cutting Height (Right Side Shown)
Figure 3-9
Refer to Figure 3-10 & Figure 3-11:
7. On both sides of the mower, loosen all nuts on the
deck lift threaded rods and hardware on the adjuster
until all deck lift chains are loose and the deck is
sitting tightly on all three blocks.
Deck Level Adjustment (Right Side Shown)
Figure 3-10
Height Adjusting Stop
Stop Handle
24911
24911
Deck Lift Chains
Deck Lift
Threaded Rod
Nuts
Nuts
Deck Level Adjustment (Right Side Shown)
Figure 3-11
Refer to Figure 3-12:
8. Loosen the two nuts on the front of height indicator
so that the foot pedal is free.
Deck Lift Rod Adjustment (Left Side of Foot Pedal Shown)
Figure 3-12
24911
Adjuster
5/16”
Adjuster Bolt
Hardware
Jam Nut
24897
Nut
Foot
Pedal
Deck Lift
Block
Height
Indicator Rod
Nut
Left Front
Deck Lift Chain