Land Pride Accu-Z Razor 357-187M - Manual (Page 32)

30
Section 5: Maintenance & Lubrication
Z44 & Z52 (S/N 526171 & Above) Accu-Z Razor ® Zero Turn Mowers 357-187M 7/22/10
Table of Contents
NOTES:
1. Initial engine oil and oil filter change is after the first 5 hours of operation. Thereafter, change engine oil and oil filter
every 50 hours of operation. Change every 25 hours when operating the engine under dusty or dirty conditions,
heavy load, high temperatures and hot weather periods. Refer to Engine Owner’s Manual.
2. Torque lug nuts initially and after first 2 hours of operation.
3. Remove cooling shrouds and clean cooling areas. Check oil cooler fins and clean as needed. Refer to Engine
Owner’s Manual.
4. Inspect pump and deck belt tensions every 6 months or 100 hours and replace if worn or cracking is noticed.
Otherwise, replace every 200 hours or 2 years whichever comes first.
5. Check fuel line hoses, fuel valve and grommet for any cracks or leaks.
6. Clean air cleaner more often under dusty conditions or when airborne debris is present. Replace air cleaner, if very
dirty.
7. Initial transaxle hydraulic oil and filter change is after the first 50 hours of operation. Thereafter, change transaxle
hydraulic oil and filter ever 200 hours of operation.
8. X/M = Service per hours indicated in column or monthly (whichever comes first).
Maintenance
Maintenance Schedule
Service at Intervals Indicated Every
25 Hours
Every
50 Hours
Every
100 Hours
Every
200 Hours
Refer to
Page
Clean mower, Deck & Engine Cooling System Daily (After engine has cooled.) 30
Verify Safety Start Interlock System Daily (Before each use) 13
Inspect Unit for loose hardware and damage Daily (Before each use) 30
Visually Inspect Tires Daily (Before each use) 32
Check Engine Oil Level Daily (Before each use & every 4 hours thereafter) 36
Clean Air Intake Screen Daily (Before each use & every 4 hours thereafter) 36
Check Fuel Level Daily (Before each use) 35
Blades - Sharp & Securely Fastened Daily (Before each use) 31 & 39
Discharge Chute -
Securely In Place & In Lowest Position Daily (Before each use)
Service Air Cleaner (6) X 36
Grease Blade Spindle Bearings X 41
Change Engine Oil & Filter (1) X 36
Clean Cylinder And Head Fins X 36
Check Battery Connections X 9 & 32
Check Tire Pressure With A Gauge X 32
Clean Engine Exterior (3) X 36
Tighten Lug Nuts On Wheels (2) X 31
Grease Deck Lift Pivot Points (8) X/M 42
Grease Front Axle Center Pivot (8) X/M 42
Grease Caster Wheel Bearings X 42
Check Pump And Deck Belt Tension (4) X 37
Check Fuel and Hydraulic Lines (5) X 35
Replace Air Cleaner Paper Element X 36
Change Fuel Filter X 36
Replace Spark Plugs X 36
Change Transaxle oil & Filter (7) X 33