Lenovo 6532 User Manual
Page 99
Table 5. DSA Preboot messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 7 “Parts listing, RS210 Types 6531, 6532, 6533, and 6534” on page 175 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
• If an action step is preceded by “(Trained service technician only),” that step must be performed only by
a Trained service technician.
• Go to the Lenovo support Web site at to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Message
number
Component Test
State
Description
Action
202-802-xxx Memory
Memory
Stress Test
Failed
General
error:
memory size
is insufficient
to run the
test.
1. Make sure that all memory is enabled by
checking the Available System Memory in the
Resource Utilization section of the DSA event
log. If necessary, enable all memory in the
Setup utility (see “Using the Setup Utility” on
page 197).
2. Make sure that the DSA code is at the latest
level. For the latest level of DSA code, go to
.
3. Run the test again.
4. Run the standard memory test to validate all
memory.
5. If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
.
202-901-xxx Memory
Memory
Stress Test
Failed
Test failure.
1. Run the standard memory test to validate all
memory.
2. Make sure that the DSA code is at the latest
level. For the latest level of DSA code, go to
.
3. Turn off the system and disconnect it from
power.
4. Reseat the DIMMs.
5. Reconnect the system to power and turn on
the system.
6. Run the test again.
7. If the failure remains, go to the Lenovo Web site
for more troubleshooting information at
.
Chapter 4
.
Diagnostics
91