LG 39E Multi User Manual

La gard locks bv, Generally

Advertising
background image

Kantooradres:

Postadres:

Vlijtstraat 40

Postbus 127

NL-7005 BN Doetinchem

NL-7000 AC

H.R. te Arnhem nr: 09087869

Tel: (+31) 314 376 876

E-mail: info@lagard.nl

Internet: http://www.lagard.nl

BTW nr: NL 8038.72.987.B01

Fax: (+31) 314 376 878

LG 39E Combogard EN

Revise: 1

Datum: 16-02-05

1

LA GARD Locks BV

OPERATING INSTRUCTIONS LG 39E Multi User Combogard /Swingbolt

Keypad 3035, 3710, 3750 or 3750K with reading contact

Lock 39E

Generally

Each pressing of a key is confirmed by a signal (an acoustic signal and a LED flash). A valid code is

followed by a double signal, an invalid code by a triple signal. After an interval of more than 10-seconds,

the already entered part of the code is deleted and the entire sequence has to be re-entered.

Code entering:

Enter the seven-digit numeric code–or a word with 7 characters

a) Operation with parallel code:

a double signal is followed.

(manager mode)

Manager code: 1234567

b) Operation with dual codes:

Six-digit numeric codes or words with six characters.

(must be programmed)

For opening two valid codes must be entered.

Manager code: 123456 and User ID# 654321

Opening:

Combogard: Enter the code and (after double signal) turn the

entry clockwise within 3 seconds unto the hold. The lock is open

and the entry is rotated.

Swingbolt: Enter the code and (after double signal) turn the

handle within 3 seconds into the OPEN position.

If the lock is not opened within 3 seconds, it is automatically

locked again.

Locking:

Combogard: Turn the entry counter-clockwise unto the hold.

The lock is automatically closed and the entry stands straight.

(Check this by trying to turn the entry back again)

Swingbolt: Turn the handle into the CLOSE position.

The lock is automatically locked; check this by trying to turn the

handle into “OPEN” position.

I M P O R T A N T

Check the lock to be locked.

Wrong try penalty:

After four invalid codes, the entry is blocked for about 5

minutes. During this period, the lock signals at 10-second

intervals. After this time penalty, the entry of every second

invalid code initiates a new 5 minutes delay period.

The key pressing is refused with a triple signal.

Change of code:

The user can change its code anytime.

(always with open door)

Enter the code and keep pressed the last number until second

double signal (LED is on), press the “0” and enter the new code

(double signal), enter the new code once more for confirmation

(double signal).

The new code is now valid. If mistakes are made while

changing the code or if an interval occurs of more than 10

seconds, the old code remains valid and the entire sequence

has to be re-entered.

Test the new code several times by open door!

Contact of

the audit trail

LED

3035

3710

3750

3750K

Advertising