Lucent Technologies 6402D - Manual (Page 7)

3
Note: The privacy of the Whisper Page announcement cannot be
guaranteed when telephones have modular base units other than the
M10L-8400 plugged into the Handset jack. The M10L-8400
(Comcode: 407639715; PEC: 3122-022) is the only modular base unit
that should be used for the 6400 Series terminals. For more
information, see the instructions for the Whisper Page feature in the
Voice Features section.
Call-Handling Features
The Conference feature allows you to conference up to six parties (including
yourself) on a call.
To add another party to a call (for a total of six parties)
1. Press .
2. Dial the number of the new party and wait for an answer.
3. When you want to add the new person, press again.
4. Repeat Steps 1 through 3 for additional conference connections.
To add a call you have put on hold to another call you are
connected to
1. Press .
2. Press and then release the switchhook.
3. Press again.
The Hold feature puts a call on hold until you can return to it.
To keep a call on hold while you answer another call or perform another
task
1. Press .
To answer a new call while active on another
1. Press .
2. To be connected to the incoming call, press and then release the
switchhook.
To return to the held call
1. Press and then release the switchhook again.
Note: If your telephone is connected to DEFINITY Release 7.1 or a later
release and if there is only one call on hold at your telephone, you can
transfer the call or initiate a conference call by pressing
or
without first returning to the held call.
Conference
Hold
Conf
Conf
Conf
Conf
Hold
Hold
Trnsfr
Conf
230738i3.book Page 3 Thursday, July 8, 1999 3:40 PM