Linn 500 Solo - Manual (Page 26)

18
The Klimax has both single ended and balanced inputs, selected by a switch
on the back panel. Use the appropriate one to suit your choice of preamplifier
and cabling. LEDs indicate which input is selected. Both signals are echoed
out the single ended ‘line out’ socket to enable daisy chaining of amplifiers.
This switch does not directly pass the audio signal but instead sends a
control signal to distortionless solid state switches.The standard output
connectors are two Neutrik 4 contact speaker sockets. They each have two
‘hot’ and two ‘cold’ connections making it easy to connect two speaker cables
per connector. If you wish to run individual speaker cables to a four way
speaker, use all four connections. All connections are identical and connected
directly to the amplifier output. The Neutrik part was chosen for its high
quality and connection integrity, compactness and international safety
approvals. Please contact us if you wish an alternative type of loudspeaker
connection.
Inputs and Outputs