Lexmark 4076-0XX - Manual (Page 32)

4076-0XX
20
Print Quality Service Check
FRU OR PROCEDURE ACTION
1 Print Cartridge Be sure the machine has a known
good print cartridge.
2 Print Head Carrier Assembly Reseat the print head cable in the
system board and check the following
parts for wear or damage:
Print Cartridge Latch
Latch Spring
Carrier
3 Purge Test Perform the “Purge Test” on page 25 .
Look for a break in the diagonal line
at the bottom of the test pattern. A
broken line indicates one or more
print nozzles are not working. Run the
test again to verify the failure If there
are even breaks in the diagonal line
similar to the pattern shown below,
replace the system board.
If there is a single break or random
breaks in the diagonal line check the
following:
• Print head cable - check the gold-
plated contacts on the end of the
cable that connects to the carrier for
dirt and wear. Use only a clean dry
cloth to clean the contacts. Also
check the cable for damage. You
may need to remove the cable from
the carrier to inspect it.
• Rubber Backer - a worn rubber
backer will result in poor contact
between the
print head cable and
the print cartridge. Check the rub-
ber backer for wear