Lexmark 4076-0XX - Manual (Page 62)

Preventive Maintenance 50
4076-0XX
Preventive Maintenance
11
This chapter contains the lubrication specifications. Following these
recommendations can help prevent problems and maintain optimum
performance.
Lubrication Specifications
Lubricate only when parts are replaced or as needed, not on a
scheduled basis. Use no. 23 grease to lubricate the following:
•
All gear mounting studs
•
The right end of the exit roller at the right side frame
•
The right end of the small feed roller at the right side frame
•
The left end of the large feed roller at the left side frame
•
Both ends of the ASF pick roll shaft at the ASF side frames
•
Transport belt idler pulley hole
•
Inside surface of the transport idler pulley tension wedge where it
touches the left side frame.
Do not lubricate the carrier guide rod orcarrier guide rod bearings.