Lincoln Electric IM359-G - Manual (Page 25)

LN-25
C-5
ACCESSORIES
K444, K444-1 OR K444-2 REMOTE VOLTAGE
CONTROL KIT
(Not required if using K431-1 or K624-1 Remote
Output Control Kit or K460-1 Pulse Power Adapter
Kit.)
The Remote Voltage Control Kit provides remote
(10K ohm rheostat) control of power source output
arc voltage level.
K444 connects to power sources with control
terminal strip connections for lead numbers 75, 76
and 77.
K444-1 connects to power sources with a 6-pin
control receptacle.
NOTE: To use a K444-1 with power sources with
only a 14-pin control receptacle, a K864 Adapter is
required to connect to K444-1 and if using a power
source without an output control switch, a K484
Jumper Plug will also be required to jumper the
output pilot circuit (2-4).
K444-2 connects to power sources with a 14-pin
control receptacle and provides a 2-4 jumper to
activate power source output.
Installation Instructions are included with the kit.
K577-1 REAR HANDLE KIT
(For LN-25 model codes above 9383)
The fold-down handle mounts to the rear of the LN-
25 case per the Installation Instructions (M16567)
shipped with the kit.
This handle provides a means to also carry the LN-
25 in the vertical position, especially convenient for
passing the unit through a manhole.