Lenoxx Electronics CD-511 - Manual (Page 4)

IB-CD511(TA)-SW-E-091002
CHOOSING A POWER SOURCE
AC power or batteries may be used as a power source.
TIP
•
Replace the batteries
when the display dims or
when the player stops
operating. Replace all
batteries with new ones.
Before replacing
batteries, make sure
there is no CD in the
player and remember to
check the Battery Safety
Instructions on Page 2.
3
AC SOCKET
VFD DISPLAY
The VFD display only lights up when using AC
power.
L O W E R
U P P E R
1. Connecting the AC power
cord
• If the CD does not play
on batteries, this means
the batteries are almost
used up. But the radio
may continue to play on
these weak batteries
because it uses less
power than the CD
player.
Insert one end of the supplied AC power cord (located
in the polyfoam) into the socket located at the back
of the player, and the other end into a wall outlet.
2. Using battery power
Insert 8 X LR20 (size “D”) batteries (not included)
into the battery compartment.
To use the player on batteries, disconnect the AC
power cord from the player.