Listen Technologies 863.050 - Manual (Page 56)

50
LT-800
LR-400/500
DX/Local
';LVWKHQRUPDORSHUDWLRQDOPRGH/RFDOPRGHFDQHIIHFWLYHO\OLPLWDQ\LQWHUPRGXODWLRQDQGRU
interference in a busy RF environment. This is done by limiting the amount of RF gain in the receiver.
When local mode is selected, the range of the receiver is compromised. Depending on your application
DQGHQYLURQPHQW/RFDOPRGHPD\EHQHFHVVDU\IRUEHWWHUSHUIRUPDQFH';PRGHLVGHIDXOW
DX Mode (default)
';LVQRUPDORSHUDWLRQ7KHORFDOPRGHIHDWXUHFDQEHXVHG
when many frequencies are being used.
Local mode
Only strong channels will be automatically tuned in
While the unit is OFF, press and hold the channel down button and turn the unit on.
The LCD shall indicate the current setting “D” or “L”.
3UHVVLQJWKHGRZQEXWWRQZLOOWRJJOHEHWZHHQ/RFDODQG';0RGH ´'µRU´/µ
Pressing seek will enter the setting and return to normal operational mode.
LR-400/500 Operating Instructions
7RUHVHWWKHUHFHLYHUWRGHIDXOWVHWWLQJVIROORZWKHVHLQVWUXFWLRQV
Reset to default settings
Resetting to defaults
Local ';
After the receiver has been reset, the display will return with defaults present.
After the receiver has been reset
Press and hold the Up and Down channel buttons while turning the unit on.
Press and hold the Up and Down channel buttons while turning the unit on. This will light
up all segments of the display.
NOTE: The defaults are
• Channel: 01
* Channel lockout: All channels active
To change to DX/Local mode
1A
1B
1C
1D
1
1
1A
1B