Lowrance electronic GlobalMap 100 - Manual (Page 52)

46
If you have any other Magnavox or Starlink compatible
DGPS receiver connected to the GlobalMap 100, you
may need to change the settings. To do this, move the
black box to the “Configure DGPS” label and press the
right arrow key. A screen similar to the one at right ap-
pears.
These menus select the beacon receiver’s frequency
and bit rate (in bits per second). To change one of these
settings, simply highlight the menu item you wish to
change, then press the right or left arrow key until the desired number
appears.
The “STAR AUTO” menu works with the Starlink or compatible receivers
that automatically determine the frequency and bit rate. If you have one of
these receivers, leave this set to “ON”.
Press the EXIT key when you’re finished.
Serial Communication Setup
If you’re connecting a computer or other serial device
to this unit, (including DGPS receivers) you’ll probably
need to change the communications settings. To do
this, select “COM PORT SETUP” on the System Setup
menu. Press the right arrow key. The screen shown at
right appears.
Check your computer or DGPS receiver’s manual for
the proper data settings. Highlight the menu item you
need to change. Press the left or right arrow keys to
change them. The serial port defaults are 4800 baud, no parity, and 8
data bits. Press the EXIT key to erase this menu.
Reset Options
To return the unit to the original factory settings, highlight the “Preset Op-
tions” menu on the System Setup screen. Now press the right arrow key.
A message appears, asking if you want to restore the original options.
Press the right arrow key if you do, the left arrow key to quit.
If you restore the unit to the factory settings, all options such as contrast,
alarms, and other system choices are returned to their default values.
However, no waypoints, routes, or icons are erased.