LevelOne IP Power Switch IPS-0008 - Manual (Page 12)

1.3.3. Using the control buttons
You can turn on power manually for each of the eight output devices with
the control buttons provided under each status indicator A through H.
Each button allows you to set the remote control function as well as turn
power on/off for each outlet manually.
The control button has two modes of operation. Press the button
repeatedly to switch between Remote Control mode and Power On/Off
mode. When you press the control button, the IPS-0008 switches modes
as follows:
After switching modes, you need to press the control button again within
5 seconds to change the mode status.
Remote control mode
1. Press the control button once. The remote control indicator starts
flashing red.
2. Now press control button again within 5 seconds and hold for more
than 5 seconds. The remote control indicator starts flashing red at
a faster speed and then inverts its original state.
For instance, if remote control indicator is enabled (grey) before you
press the control button, it turns on (red) after step 2, indicating that
remote control is disabled.
8