Usb serverswitch rear panel connections, Step 2 -- initial start-up – Lightwave Communications USB SuperSwitch User Manual
Page 19
Lightwave Communications
USB
S
ERVER
S
WITCH
www.lightwavecom.com
Page 19 of 25
USB ServerSwitch Rear Panel Connections
Figure 6: USB ServerSwitch - Rear Panel View, Connections
Figure 6 Legend:
1)
HD15 Video for Server #1
2)
USB-B input receptacle for Server #1
3)
HD15 Video for Server #2
4)
USB-B input receptacle for Server #2
5)
HD15 Video CASCADE IN for User Console A (not used on Master)
6)
USB-A receptacle #1 for Mouse or Keyboard for User A
7)
USB-A receptacle #2 for Mouse or Keyboard for User A
8)
HD15 Video Out for User A, or Cascade Out
9)
Control Out: DB9M; sends signal for box to box communications
10)
HD15 Video CASCADE IN for User Console B (not used on Master)
11)
USB- A receptacle #1 for Mouse or Keyboard for User B
12)
USB- A receptacle #2 for Mouse or Keyboard for User B
13)
HD15 Video Out for User B, or Cascade Out
14)
Control In: DB9F; receives signal for box to box communications
15)
AC power input (IEC, universal AC power), power switch and fuse
STEP 2 -- Initial Start-Up
a) Connect the AC Power Cord to the USB ServerSwitch and plug the power cord
into a grounded outlet.
b) Connect a monitor, keyboard and mouse (optional) to the USER connections
(A or B) on the rear of the USB ServerSwitch. The mouse and keyboard for each
user can be connected to either USB-A connector, only one device per connector.
c) Turn the USB ServerSwitch on. It takes approximately one minute to boot up.
Note: At this point, it is possible to program the unit, if so desired.
Follow the steps as listed in Section 3 of this manual to access the
on-screen menus.
1
2
3
6
7
10
8
9
12
13
14
15
11
5
4