Lennox Hearth M5390 - Manual (Page 18)

16
English
10. Using the Jabra M5390 Multiuse headset with multiple Bluetooth ® -enabled devices
Your Jabra M5390 Multiuse headset can be paired with up to 8 devices. However, only two can be
connected (paired with the headset, turned on and in range) with the headset at one time. This could
be any two Bluetooth
® devices (for example, a mobile phone and the Jabra M5390 Multiuse base,
or the Jabra A335w Dongle and a mobile phone, or two mobile phones). Therefore, if the headset is
in range of the Jabra M5390 Multiuse base or Jabra A335w Dongle, only one additional Bluetooth
®
device can be connected to the headset (paired with the headset, turned on and in range).
The headset is per default paired with the base from the factory. This means that the headset will
automatically connect to the base if in range and turned on. For the dongle pairing see the dongle
manual on CD.
It is also possible to have two Bluetooth
® -enabled mobile phones connected to the Jabra M5390 Multiuse
headset simultaneously. In this case, both base and dongle should be disconnected from the headset.
11. Operating devices in multiuse scenarios
From the button interface of the headset, it is possible to operate both devices in a multiuse
scenario (two devices connected to the headset). Operations can be divided into handling for
incoming and outgoing calls.
If receiving an incoming call from either of the connected devices, this device will automatically
be the device “in focus” and a tap will answer the call. A press will reject the call.
If wanting to place an outgoing call activated from the headset, the user manually has to place
one of the devices “in focus”. Placing a device “in focus” means that all button presses made on
the headset will be sent to the given device. For example, if a Voice Dial is to be activated on
the second connected device, the user must first make sure that the given device is “in focus”.
After that, simply tap the button to activate a Voice Dial command.
In order to switch focus between the two connected devices, the Answer/End button has to be
pressed for app. 1.5 seconds.
After having made a focus-swap action, different indicators will be used to inform the user
which device is now “in focus”; If swapping focus to the Jabra A335w dongle, then the LED of
the dongle will give 5 quick light-blue flashes. Also the speaker of the headset will say “Dongle
in focus”. If swapping focus to the Jabra M5390 base, the LED of the base will give 5 quick
light-blue flashes. Also the speaker of the headset will say “Base in focus”. If swapping focus
to a mobile phone the speaker of the headset will say “Mobile in focus”.
Please note that this only applies to multiuse scenarios. If the headset is only connected to one
device, then this device will automatically be “in focus”.
Also note that the Last Number Redial command does not use the “in focus” concept. If double
tapping the Answer/End button, the Last Number Redial command will automatically be sent to
the connected device with the latest incoming call (when connected to the headset).