Paragon W18 - Manual (Page 7)

7
PROGRAMMER DISPLAY
The WW Computerized Programmer Display prompts the operator with various readings. The display
may appear peculiar due to the construction of each character in the standard LED display. Reading
that appear on the display and their descriptions are as follows.
DISPLAY DESCRIPTION
Abort The firing was stopped.
Alarm ALAR appears either when you are entering an alarm temperature or when
the alarm is sounding during a firing. To stop an alarm, press any key except STOP. If the alarm
goes off when you first begin firing, it is because it was set for a lower temperature; than the present
temperature.
Bad Program This message appears when a Ramp-Hold firing has been
programmed with 0 rate in the first segment.
Configuration This is an option that shows the factory configuration code for your
Sentry. This is for technicians who call the factory for support.
Change °F/°C Choose between operation in degrees F of degrees C.
AbRT
ALAR
bAdP
CFG
CHG-