Panasonic PT-DW7000U - Manual (Page 7)

7
Accessories
Check that all of the accessories shown below have been included with your projector.
Do not look into the lens while the projector is being used.
• Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and damage your eyes.
Do not place your skin into the light beam while the projector is being used.
• Strong light is emitted from the projector’s lens. If you place directly into this light, it can hurt or damage your skin.
Do not bring your hands or other objects close to the air outlet port.
• Heated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand heat.
Do not use the old lamp unit.
• The lamp section may break.
Replacement of the lamp unit should only be carried out after it has completely cooled
off, otherwise burns may result.
Disconnect the power cord plug from the wall outlet as a safety precaution before
carrying out any cleaning.
• Electric shocks can result if this is not done.
If the lamp has broken, ventilate the room immediately. Do not touch or bring your face
close to the broken pieces.
• Failure to observe this may cause the user to absorb the gas which was released when the lamp broke and which
contains nearly the same amount of mercury as fluorescent lamps, and the broken pieces may cause injury.
• If you believe that you have absorbed the gas or that the gas has got into your eyes or mouth, seek medical
advice immediately.
• Ask your dealer to replace the lamp unit and check the inside of the projector.
Ask an Authorized Service Center to clean inside the projector at least once a year.
• If dust is left to build up inside the projector without being cleaned out, it can result in fire or problems with
operation.
• It is a good idea to clean the inside of the projector before the season for humid weather arrives. Ask your
nearest Authorized Service Center to clean the projector when required. Please discuss with the Authorized
Service Center regarding cleaning costs.
Do not reach for the openings beside the optical lens, during horizontal or vertical
movements of the lens there is a injury hazard.
To keep our environment clean, please bring the non repairable unit your Dealer or a
Recycling Company.
Remote control unit:
[N2QAGB000024 x 1]
POWER ON OFF
RGB 1 RGB 2 AUX
MENU
STD
LENS
OSD 1
4
7
2
5
8
3
6
9
0 NEXT USER
LIGHT ID ALL
ASPECT
ID SET
Projector Computer
Numetric
BRIGHT CONTRAST
ON SCREEN
SYSTEM SEL
FUNC 1
D.ZOOM
ENTER
PAGE UP
PAGE DOWN
VIDEO SHUT S-VIDEO
FREEZE
SHUTTER
AUTO SETUP
LASER ON/OFF
Power cord:
[2CG3FZ00008 x 1] Wired cable for remote
control:
[15m (49'3"),
K1EA03NA0001 x 1] Dry batteries for remote
control (AA):