Patton electronic DIALFIRE 2977 - Manual (Page 22)

DialFire PTE ISDN T1 (PRI), Long-Haul (External T1) Configuration Worksheet 22
Model 2977 DialFire RAS User Manual 2 • Preparation
DialFire PTE ISDN T1 (PRI), Long-Haul (External T1) Configuration
Worksheet
Use the worksheet below to collect the information that may be required to complete the configuration of your
DialFire PTE adapter within your operating system environment.
Note The parameters on this page are for ISDN T1 (PRI) connected directly to an exter-
nal T1 telephone line (Long Haul). If your adapter is connected to a PBX or similar
in-house network, use the ISDN T1 (PRI), Short Haul (PBX or Other Internal Net-
work) configuration worksheet (page 24).
Parameter Value
Coding [ ] B8ZS
Framing [ ] ESF
Long Haul Line Build
Out (Level) [ ] 0dB [ ] 7.5 dB [ ] 15 dB [ ] 22.5 dB
Signaling [ ] AT&T 5ESS [ ] Nortel DMS 100/250 [ ] ETSI (Euro ISDN) [ ] INS-1500 (Japan)
[ ] National ISDN2 [ ] None
NFAS Master Port (RAS
48 PT2 Only) [ ] None
[ ] 1 [ ] 2 Interface ID for Port 1(0–127):
________ Interface ID for Port 2
(0–127): ________
Leased Time Slots List which, if any, PRI time slots are leased:
Modem Nationality Enter the country in which the PTE adapter will be installed: