Patton electronic DIALFIRE 2977 - Manual (Page 23)

DialFire PTE ISDN T1 (PRI), Long-Haul (External T1) Configuration Worksheet 23
Model 2977 DialFire RAS User Manual 2 • Preparation
After completing the worksheet, go to chapter 3, “Installing the Model 2977 adapter” on page 26.
Before You Install the
DialFire RAS B4ST
Adapter… Order the ISDN Line
If you do not have an ISDN line installed, you need to contact your telephone company
and order a Basic Rate ISDN line (2B+D) with the following recommended configuration:
Note If your telephone company supports either of the following
ISDN Ordering Codes, request that your ISDN line be config-
ured to one of them.
• EZ-ISDN 1 (Preferred)
• Capability S
If your telephone company does not support either of these Ordering Codes, request
the following ISDN line configuration:
• Switch Type: National ISDN 1 (preferred), ETSI, AT&T 5ESS, or Nortel DMS 100
• ISDN Basic Rate Interface (BRI) service (2B+D)
• 2 B channels, D channel for signaling only (no D channel packet data)
• Circuit Switched data and voice (CSD/CSV) on each channel
• Dynamic TEI
• Multipoint bus configuration
• Terminal type A (AT&T Custom switch only)
• No EKTS or special servi ces or features
*You must select a long distance carrier and forward your choice, along with the Ordering Code or line
configuration, to your telephone company
Parameter Value