Precor 946i - Manual (Page 61)

User’s Reference Manual: Display Console 12
Keypads
Use the keypads to enter your workout session selections, to affect
what appears on the display, and to establish your pedal resistance
and ramp incline preferences.
Four distinct keypads exist on the display and are discussed in this
section:
• Lower Display keypad and the Selection keys
• Navigational keypad in the center of the display
• PROGRAMS keypad
• Number keypad with the ENTER and CLEAR keys
Lower Display Keypad and the Selection Keys
Diagram 4: Lower Display keypad and the Selection keys
Left selection key: Every time you press this key, the display
reflects either the amount of time elapsed since you began your
exercise session or, it shows the time remaining. An LED lights
and indicates which information is being displayed.
TIME +/–: You can change the workout time while you are
exercising, by pressing the TIME +/– key. A blinking number
appears in the center display. You can change the number using
the navigational arrow keys or enter a different time using the
number keys. Refer to Changing Your Workout Display
Options.
CROSSRAMP: Press and hold the CROSSRAMP arrow keys
to increase or decrease the ramp incline from 1 to 20.
Changes to the ramp incline are not immediate. It takes time
for the lift to reach the target incline shown on the display.
Important: Ramp changes occur only when the foot pedals
are in motion. The number that appears on the display
indicates the selected range, not the degree of incline. There
is not a one-to-one relationship between the degree of incline
and the CrossRamp setting. Refer to Table 3.
Table 3. Association between Crossramp settings and
degrees of incline
PAUSE/
RESET
TIME PAUSE/
RESET
TIME ELAPSED
TIME REMAINING
DISTANCE
STRIDES/MIN
TOTAL STRIDES
QUICK
START
C
RO
SSRAMP RESISTANCE
Unit CrossRamp Setting Degree of Incline
EFX576i 1 through 20 15° through 40°
EFX546i 1 through 20 15° through 40°
EFX556i Stationary Fixed at 20°