Precor 946i User Manual
Page 95
EFX546i Elliptical Fitness Crosstrainer Assembly Guide
5
Rear
view of
console
A
ttach both upright supports to the base frame using eight
buttonhead screws (A), eight split washers (C), and eight
washers (B). Finger tighten.
Ask your assistant to hold the display console above the upright
supports while you connect the cable. Remove and discard the tape
after you connect the cable.
Important: Place excess cable inside the upright support.
H
ave your assistant lower the display console while you align the
mounting brackets on the inside of the upright supports.
F
asten the display console to each upright support by threading a
buttonhead screw (A), washer (B), and split washer (C) through
opposite mounting holes. Check that the base fasteners are loose
before installing the display console fasteners.
CAUTION: Make sure the display console screws are properly
threaded into the inserts. Do not cross thread. The Precor
Limited Warranty does not cover damage that occurs during
installation.
C
heck alignments and thread the remaining four display console
screws (A), four washers (B), and four split washers (C). Wrench
tighten with a
³⁄₁₆-inch hex key so the assemblies come together, but
leave room for adjustments.
W
hen all fasteners are snug against the unit, begin at the base and
alternately wrench tighten all fasteners. Follow the sequence from
step 4 through step 8.