PYLE Audio PLINV3 - Manual (Page 7)

TROUBLE SHOOTING
SYMPTOM A: NO AC POWER OUTPUT, THE RED LED LIGHTS.
SYMPTOM B: NO AC POWER OUTPUT, NO LED LIGHTS ARE ON.
6
POSSIBLE CAUSES SUGGESTION
The connected AC products are rated at more than 150 Watts
(PINV1) , 300 Watts (PINV2) or 400 Watts (PINV3), the
overload shutdown occurred.
Use the product with a total power rating
less than 150 Watts (PINV1) , 300 Watts
(PINV2) and 400 Watts (PINV3) .
The connected AC products are rated at less than 150 Watts
(PINV1) , 300 Watts (PINV2) or 400 Watts (PINV3), the high
starting surge causes the overload shutdown.
Use the product not exceeds the inverter's
surge capacity, 300 Watts (PINV1) , 600
Watts (PINV2) and 800 Watts (PINV3) .
The battery is discharged (alarm sounds) Recharge battery.
The inverter overheated Turn off the inverter and allow to cool for 15
minutes. Clear blocked fan (PINV2 / PINV3)
or remove the objects covering the ventilation.
POSSIBLE CAUSES SUGGESTION
The lighter socket or 12 Volt outlet has been poor contacted Press plug into socket firmly.
The lighter socket or 12 Volt may require ignition to be on. Turn key to accessory position.
The fuse of cigarette lighter or 12 Volt outlet is blown Check vehicle fuses and replace.
The fuse of inverter is blown Check to make sure the inverter is
connected to a power source with correct
voltage and polarity.
Replace fuse.
The inverter has been connected with reverse DC input
polarity.
The inverter needs repairment
if the probable damage has occurred.