Panasonic CF-W8 - Manual (Page 84)

84
LAN
NOTE
z Even when a password is set in the Setup Utility and [Password on boot] is set to [Enabled], entering the password is
unnecessary for turning on or resuming the computer.
z Connect the AC adaptor.
z The Power On by LAN function is off under the following conditions:
• When you turn the computer off by sliding the power switch for four seconds or longer (e.g., after a hung-up).
• When you reattach the AC adaptor and battery pack to the computer after removing them.
z The screen remains dark after the computer resumes from standby. The previous screen display will be restored when
you touch the keyboard, touch pad or touchscreen (only for CF-T8 Series).
Enabling the Power On by LAN function
The computer automatically turns from off to on when the computer is accessed from the network server via the internal LAN
port.
1
Select [Allow] in [Power On by LAN] in the [Advanced] menu of the Setup Utility
( Î page 100 ).
2
In [Caution], press Enter .
3
Press F10 , and then select [Yes] and press Enter .
4
Log on to Windows as an administrator.
5
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] -
[Device Manager], and double-click [Network adapters] and double-click [Intel(R)
82567LM Gigabit Network Connection], and then click [Advanced].
6
Click [Enable PME] in [Property] and select [Enabled] in [Value].
z The computer may accidentally turn on if the linkage status is changed. To prevent the accidental startup, make
the following setting.
Click [Wake on Settings] in [Property] and select [Wake on Magic Packet] in [Value].
7
Click [OK].
Power On by LAN/Wake Up from Wired LAN