Panasonic TC-26LX60L - Manual (Page 6)

10 11
V
iewing
W
atching V
ideos and DVDs
W
a
tching
TV
VCR DVD
Rewind/Fast Forward Reverse/Forward
Play Play
Pause Pause
Stop Stop
VCR Record -
TV/VCR Open/Close
Channel Down/UP Slow Reverse/Forward
10
Vivid 1080i Full 30 SAP
Input select
[1] TV
[2] Component
[3] HDMI
[4] Video1
[5] Video2
[6] Video3
Video1
VCR
Watching TV
Connect cable Box when watching cable TV. (p. 8)
1 3
2
Switch to TV mode
Turn power on
Select a channel number
up
down
or
Ŷ Other Useful Functions (Operate after )
Sleep Timer
Information
Recall
•
0/30/60/90 (minutes)
Switches the unit OFF in a preset amount of time from 0 to 90
minutes in 30 minute intervals.
Ŷ Selects Audio Mode for TV Viewing
Displays or removes the channel banner.
Ch/input mode
SAP Signal
resolution
Picture mode
Sleep timer
remaining time Aspect
ratio
Change
aspect
ratio
Change the aspect (p. 26)
•
Press button to cycle through the aspect modes.
• 480i, 480p:FULL/JUST/4:3/ZOOM
• 1080i, 720p:FULL/H-FILL/JUST/4:3
Note
•
Reselect “Cable” or “Antenna” in “ANT in” of “Auto program” to switch the signal reception between cable TV and
antenna. (p. 15)
•
The channel number and volume level remain the same even after the TV is turned off.
Press SAP to select the desired audio mode.
• Each press of SAP will change the audio mode. (Stereo/SAP/Mono)
• Red display : With signal
White display : No signal
White display (All modes) : Mono
Listen
with SAP
(Secondary
Audio
Program)
Watching Videos and DVDs
Some Panasonic equipment connected to the TV unit can be operated with the remote control.
Programming the remote control is necessary to operate other manufacturers’ products. (p. 18, 23-24)
With VCR or DVD turned On
Switch to external input
Press to display the Input select menu.
Press the corresponding
NUMBER key on the Remote
Control to select the input of
your choice.
Press to select the input of your
choice, then press “OK”.
•
If during selection, no action
is taken for several seconds,
the Input selection menu is
exited.
•
The terminal and label of the connected
equipment is indicated.
To label each of the connected equipment
(p. 14)
or
Operate
the VCR or DVD with the remote control
•
For details, see the
manual of the other
equipment
or ask your local
dealer.
Select the input mode
(example)
(For other operations, see p. 22)
Label
[example]
Terminal
Note
3
1
2
select
enter
Stereo Two channel Audio reception.
SAP Second Audio Programming
( typically used for bilingual audio ).
Mono Select when stereo signal is weak.
•
Video 3 is not available for TC-23LX60.
Ŷ Press to exit or return
to previous screen
[example]