Paradyne 4300 - Manual (Page 13)

4300 Remote Broadband Access Concentrator Installation Instructions
Have the following equipment ready before beginning this procedure:
- One drill
- One 3/8” drill bit
- One 7/16” wrench or socket
- One ½” wrench or socket
- A pencil
- Optional wall mounting kit
Follow the sequence below for Wall Mounting.
1. Pre-assemble the upper and lower wall mounting brackets to the cabinet as shown above.
2. Position the cabinet with mounting brackets against the wall and mark on the location of the mounting holes
on the wall.
3. Drill six (6) 3/8” diameter holes completely through the wall at the locations marked in step 2.
4. Lift the cabinet with mounting brackets into position against the wall.
5. Insert 5/16” diameter bolts through the upper mounting bracket.
6. Secure the cabinet to the wall by installing 5/16” flat washers, lock washers and nuts to the bolts inserted in
step 5.
7. Repeat steps 5 and 6 for the lower mounting bracket.
Lifting eyelets are provided to facilitate hoisting if desired.
4300-A2-GZ40-00 July 2004 13