Panasonic RQT9633-4P - Manual (Page 7)

7
RQT9633
EN
GL
IS
H
3
Attach the wall mount bracket to the wall with 2
screws (not supplied). (Both sides)
≥ Use a spirit level to ensure both wall mount brackets
are level.
≥ Make sure that the screw used and the wall are
strong enough to support the weight of at least
33 kg (72.8 lbs).
4
Fix the safety holder onto the unit with the
screw (supplied).
{. Screw tightening torque: 50 N0cm (0.4 lbf0ft) to 70
N0cm (0.5 lbf0ft).
5
Attach the fall prevention cord (not supplied) to
this unit.
≥ Use a cord that is capable of supporting over 33 kg
(72.8 lbs) (with a diameter of about 1.5 mm ( 1 /
16
q)).
6
Hook the unit securely onto the wall mount
brackets with both hands.
≥ Connect the FM antenna and the AC power supply
cord to the unit before hanging the unit onto the
wall. (> 8)
≥ After hanging the unit, release your hand carefully
to confirm the unit sits securely on the wall.
7
Drive the safety holder fixing screw
(not supplied) to secure the safety holder onto
the wall.
≥ Make sure that the screw used and the wall are
strong enough to support the weight of at least
33 kg (72.8 lbs).
≥ Refer to step 3 for requirements before screwing.
8
Attach the fall prevention cord (not supplied) to
the wall.
≥ Make sure that the screw used and the wall are
strong enough to support the weight of at least
33 kg (72.8 lbs).
≥ Make sure that the slack of the cord is minimal.
At least 30 mm (1 3 /
16 q)
‰7.5 mm ( 19 / 64 q) to
‰9.4 mm ( 3 /
8
q)
4 mm
(
5 /
32
q)
Wall mount bracket
Screw
(supplied)
Cord (not supplied)
Wall
Safety holder fixing screw
(not supplied)
Safety holder
Fixed to the wall
Cord (not supplied)
Screw eye (not supplied)
Wall
SC-HC37~RQT9633.book 7 ページ ２０１２年２月２８日 火曜日 午後３時４３分