Prismacolor CEILING MOUNT CB-200 - Manual (Page 2)

Prismasonic Ceiling Mount CB-200
Assembly Instructions
Prismasonic Ceiling Mount CB-200
Assembly Instructions
Introduction
In order to achieve a stable assembly, it is necessary to attach
the projector body to the mount at least from the three spots.
There are many different ways to attach the projector + lens to
the mount, but probable only the one most optimal solution.
The important issue is that the
universal base plate is mounted
as close to the centre of gravity of projector + lens combination
as possible. Note that the weight of lens is around 3.4 -3.8 kg
depending on the model.
STEP 1
Turn around your projector upside down and arrange the fastening arms on the bottom (Fig 1). The universal
base plate is attached to the projector body with the aid of short connector arm + extension arm (example1), or
using only the short connector arm (example2), or to connect the plate directly to the projector using the bot-
tom spacer below the plate (example2), or with the aid long connector arm (example3). The connection method
for the projector body depends on where the centre of gravity spot locates in relation to the screw threads of the
projector. Make sure the both axes of the universal base plate are at rectangular position related to the projector
optics. The truss head screws M4,5,6 x 15,20,25 are for attaching the arms to the projector body, while the cap
screws M6x10 are for attaching the arms to the universal base plate (look examples). Tight all the screws first
only to an amount that the arms still are loosely held.
Figure 1
The long connector arms extending the projector's front edge are attached to the universal base
plate with cap screws, M6x10 and square nuts, M6 (example3), and to the rectangular plate of lens
stand with cap screws, M6x12. Check that the lens is now orthogonally as close as possible to the cen-
tre of the projector optics. After everything is appropriately positioned make the final tightening of all
screws.
NOTE! You will have to tilt the lens to the direction of the light path (watch the Lens Manual). This lens
tilting needs some extra space between the projector optics and the lens.
Example 1 Example 2
Example 3
STEP 2
Install the ceiling mounting plate to the cor-
rect location on ceiling (Fig 2) (installation
parts not included) . Please consult the profes-
sional installer if you do NOT know an appro-
priate way to attach heavy loads to your
ceiling material.
Figure 2