Prismacolor CEILING MOUNT CB-200 User Manual
Page 3
Assembly Instructions
Prismasonic Ceiling Mount CB-200
Prismasonic Ceiling Mount CB-200
Assembly Instructions
STEP 3
First align two holes on the lower extension
rod at the suitable holes on the upper exten-
sion rod, tighten them with cap screw, M8 x
55 and self-locking nut, M8. Use the two truss
head screw, M6 x 5 on sides for locking the
rods to each other completely (Fig 3).
Now attach the extension rods to the universal
base plate connector with cap screw, M8 x 55
and self-locking nut, M8 refer to Fig 3. Tighten
screws and nuts, including the all screws and
nuts of universal base plate connector securely
using the L -wrench, 6 mm and Spanner
wrench.
Lift the whole setup from the extension rods to
the ceiling and attach it to the ceiling mount-
ing plate using the three cap screws, M8 x 55
and Self-locking nuts, M8 refer to Fig 3.
Tighten the screws again securely with L -
wrench, 6 mm and Spanner wrench.
In order to minimize the drop from ceiling, projec-
tor + lens can be mounted directly to the ceiling
mounting plate without the extension rods re-
fer to Fig 5. Loose the two cap screws, M8 x 15
from the unused part of universal base plate
connector and attach the ceiling mounting
plate to the modified base connector using the
screws and the two self-locking nuts, M8, exactly
as shown in Fig 5.
Figure 3
Finally insert the two Prismasonic logo plates
to the ceiling mounting plate (Fig 4). In order
to get the flanges of the logo plates inserted,
the assembly screws of ceiling mounting plate
have first to be loose a bit.
Figure 4
Figure 5
To ensure correct usage, please read this instruc-
tions manual thoroughly. Keep this manual for
future reference.
Brackets should be mounted only by a qualified
installer
User will be responsible for any injuries and dam-
ages that may arise from improper installation and
handling of Ceiling mounting kit
Ensure all mounting screws are appropriately posi-
tioned and properly tightened/fastened
Installers are to ensure everyone’s safety during
installation
Important Notes!