P3 International P3 E9310 - Manual (Page 7)


When you open the unit, you will see the DIP switch located on the circuit
board (see diagram below).
The DIP switches numbered 1-3 are used for addressing. The DIP switch
numbered 4 is used for choosing measuring units (ºF or ºC). The default
values set at the factory are address 8 and degrees Fahrenheit (ºF).
If you plan on using this unit in conjunction with a compatible receiver,
choose an unused address in your set. Check the addressing diagram
below.
Choose the measuring units as per the diagram below.
Close the housing carefully as described in chapter 5.2
6. Operation
ON
1 2 3 4
ON
1 2 3 4
˚F
˚C
Addressing
1
2
3
4
5
6
8
7