Pico Macom PR3200 - Manual (Page 10)

PICO MACOM INC. 12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 (800) 421-6511
PROGRAMMING
1. Plug the AC cord to an AC outlet and turn
on the receiver.
2. If the receiver has not been pro-grammed
for the last channel, the display shows "1"
which indicates CH.1.
3. Normally, the receiver has been preset
and factory programmed. See the preset
Channel Table attached.
4. Select the channel number to be pro-
grammed by using "+"/"-" keys
Video I.F. Frequency:
5. Start programming by pressing “SET”
key. The first pressing of the “SET” key is
for programming the video i.f. frequency.
The display shows the reading of the i.f.
frequency. Usually, the frequency shown is
the preset frequency of this channel.
6. Program the i.f. frequency by using the
“+”/”-” keys.
7. Press “+”/”-” keys once at a time, the
frequency moves up/down in increments of
250KHz. The LED indicator on the right
side of the main display indicates the changes.
The display of the change would be carried
to the main display every 1MHz.
8. Continue to press the “+”/”-” for more
than one second. The rate of frequency
increment/decrement will be sped up/down
for faster programming.
Audio Mode/
Audio Carrier Frequency
9. Press the "SET" key again. The second
pressing of the "SET" is for programming
the audio sub-carrier frequency.
10. Normally, the audio mode is preset in
MONAURAL and the audio sub-carrier.
frequency is preset at 6.80MHz and is the
9
only mode that is currently operational. Dis-
regard modes 2, 3, & 4.
MODE DISPLAY STATUS
1. A.6.80 MONO/6.80MHZ/
Wide Band
11. Use “MODE” key to select AUDIO
MODE 1.
12. Use the "+"/"-" key to program the audio
sub-carrier frequency.
13. Press "+"/"-" key. Each time the fre-
quency moves up/down 10KHz.
14. Keep pressing the "+'/"-" key for more
than one second. The rate of frequency incre-
ment/decrement will be speed up/down for
faster programming.
15. Press the set key again. This third press-
ing of the "SET" key is to program the polar-
ity. and LNB inputs. Currently, the only
mode that is operational is MODE 1. Audio
Sub-carriers from 5.0MHz to 8.0MHz can be
accessed in this mode. Disregard MODES 2,
3 & 4.
MODE DISPLAY POLARTIY LNBINPUT
1.
U. 1. Vertical 1.
Completion of Programming:
In SMATV application, automatic LAST
channel set-up may be reqiired accidental
power failure. The procedure for LAST chan-
nel programming are as follows.
1. Select the number of the LAST channel.
to used by using "+"/"-" keys.
2. Press "SET" key 4 times, and confirm all
of the parameters as they are going through
the display.
3. As soon as the display goes back to channel
display, the LAST channel programming is
completed.