Pico Macom PR3200 - Manual (Page 7)

PICO MACOM INC. 12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 (800) 421-6511
R E A R P A N E L
FRONT & REAR PANEL
6
950-1750
MHz INPUT
LNB
Power
IN
70 MHz
IF LOOP OUT
INV NORM
FLAT
VIDEO OUT
COMP
VIDEO OUT VIDEO AUDIO
B/MAC VIDCIP
H V
3/8 A 250V
FUSE
120V
60 Hz 0.3A
IF GAIN
9 10 11 12 13 14 15 16 17 18 19
600VA MAX
UL LISTED
69NO
E97199 0694
MODEL: D6-1007
INPUT:120V 60Hz 25W
OUTPUT: 18VDC 250 mA
AC ADAPTOR
PLUG IN CLASS 2 TRANSFORMER
8
20
8.
RF Input:
Input connection from C-band or Ku-band
LNB. ( 950 to 1750 MHz). Also provides
+18VDC output if PS-18DC is connected
to
10 LNB Power.
9.
LNB Power:
This 3.5mm RCA jack accepts the optional
PS-18DC LNB power supply voltage.
10.
I.F. Loop:
The 70 MHz IN and OUT connectors loop
the un-filtered tuner output for possible
terrestrial interference filtering. Normally
the short jumper is connected and the IF
gain is set to maximum (fully CW).
11.
Video Invert:
The Normal/Invert switch controls the
video polarity of the the output amplifiers.
Toggling the switch affects all three video
outputs.
12.
Flat Video Out:
A one volt peak to peak unfiltered,
unclamped and non de-emphasized signal
is provided for MAC type decoders.
13.
Comp Video Output:
A one volt peak to peak composite CCIR
405-1 525 line de-emphasized, unfiltered
and unclamped video signal is provided for
the VideoCipher®II decoders.
14.
Video:
A one volt peak to peak composite CCIR
405-1, 525 line de-emphasized, filtered and
clamped video signal is provided for
unscrambled programming.
15.
Audio:
Standard RCA connection to feed either a
descrambler or a SMATV modulator
16.
H/V Electronic A/B Terminal:
A switching +5/-5 VDC voltage is provided
between the push terminals to control a
PICO MACOM ABE-C/Ku H/V switch.
17.
Fuse:
Replace this fuse with only one of the same
rating as indicated on the chassis.
18.
Convenience Outlet:
The AC outlet is capable of delivering up to
600 watts of AC power.
19.
Power Cord:
Connect to 108 to 125 VAC, 50/60 Hz
electrical outlet.
20.
PR-18DC:
Optional power supply to power LNB.